Tech
Stuff
- Most intermittent problems are caused by faulty electrical connections or wiring. Perform careful check as described at start of Section "B". Check for:
- Poor mating of the connector halves, or terminals not fully seated in the connector body (backed out).
- All connector terminals in problem circuit should be carefully reformed to increase contact tension.
- Poor terminal to wire connection. This requires removing the terminal from the connector body to check. See Introduction to Section "6E".
- If a visual check does not find the cause of the problem, the car can be driven with a voltmeter connected to a suspected circuit. An abnormal voltage reading when the problem occurs indicates the problem may be in that circuit.
- A “Scan” tool can also be used by monitoring the suspected problem circuit and moving related wiring and connectors . See Introduction to Section "6E" on how each "Scan" tool position can be used.
- Open ignition coil ground and arcing at spark plug wires or plugs.
- “Service Engine Soon” light wire to ECM for short to ground.
- Diagnostic “Test” terminal wire to ECM for short to ground.
- ECM terminals “A” and "U" to engine ground. Check for loss of trouble code memory by grounding the dwell lead for 10 seconds with “Test” terminal left ungrounded. Code 23 should be stored after engine is stopped and ignition turned to “run” position. If not. the ECM is faulty.
- Check for an electrical system interference caused. by a defective relay, ECM driven solenoid, or switch. They can cause a sharp electrical surge. Normally, the problem will occur when the faulty component is operated.
- Check for improper installation of electrical options, such as lights, 2-way radios, etc.
- EST wires should be kept away from spark plug wires, distributor wires. distributor housing, coil, and generator. Wire from ECM terminal “13” to distributor should be a good ground.