64V2488 Rehabilitation
11 - 16 June 2001
The access hole to the new Dual master Cylinder needs to be enlarged a bit. Just the job for a nibbler. Some brass hinges will finish this and then on to the welding. Have to get ready for tomorrows show at SullY
(Got the door fixed!)
The smaller one was reinstalled laterally and cranked into position. Watch the door swing shut..
If you recall the problem with this door was that it wouldn't close correctly due to the sag from the years on no support under the pillar.
After the braces were in place, with the door open 2-3 feet, I let go of the handle and allowed the weight of the door swing it shut.
Still closing
SHUT!.... with no help....
Some final touches before welding starts