64V2488 Rehabilitation

(Picture Archive, Restoration, 64V-2488)

22 April 2000(P) Renovate pinion seal and universals

The car is an early 64 and caused some headaches because, contrary to the listings, both universals were 63. The pinion seal is standard through the years. To install, remove the driveshaft, lock the yoke with a bar and unbolt the large central nut holding the yoke to the pinion gear shaft. Pry out and replace the seal and retorque the yoke.

[ Main ] [ ]

These pages and programming contained therin are © 1996 - , Bob Johnstone and may not be reproduced without the permission of rfjohnstone at cox.net (Bob Johnstone) All Rights Reserved.
Some technical opinions are my own from experience, other informational data is from online sources with credits when available and while care has been taken to be as accurate as possible, it is offered only as a guide and caution should be exercised in the application of it.